• 18 Nov, 2026

From one colonial era plant at Chhatak to more than forty factories, Bangladesh now grinds far more cement than it can use: capacity near 86 million tonnes against demand of about 40 million tonnes in 2025, built almost entirely on imported clinker.

Cement is the material Bangladesh builds with, yet the industry that supplies it is barely three decades old as a mass business, and it rests on a paradox. Bangladesh has built far more grinding capacity than its builders can currently use, while producing almost none of the clinker, the main ingredient, inside its own borders. According to the Bangladesh Cement Manufacturers Association (BCMA), the country had 41 cement plants with a combined annual capacity of 86.02 million tonnes in early 2026, against domestic demand of 39.75 million tonnes in 2025; other statements by the same association put installed capacity closer to 100 million tonnes. Whichever figure is used, the industry runs at well under half of what it could produce, and its story is one of rapid private expansion, imported raw materials and a construction cycle that has turned sharply against it since 2022.

Origins: One Plant on the Surma

The industry begins with a single factory. The Chhatak Cement Factory, on the bank of the Surma River in Chhatak Upazila of Sunamganj district, was established in 1937 as a private company named the Assam Bengal Cement Company, in what was then British India. It remains the first and oldest cement factory in Bangladesh.

After the Indo-Pakistani war of 1965, the factory was abandoned by its private owner and came under the Pakistan Industrial Development Corporation in 1966. After independence it passed through state hands and, from 1 July 1982, has been run by the Bangladesh Chemical Industries Corporation (BCIC). Its scale was always modest: initial annual capacity of about 60,000 tonnes, raised in 1987 to roughly 0.2 million tonnes, using the old, fuel-hungry wet process. By the time it last operated, in March 2020, ageing machinery had reduced output to a few hundred tonnes a day.

A modernisation project begun in 2016 was meant to convert Chhatak to the dry process and lift output to 1,500 tonnes a day. It missed successive deadlines, its cost rose well beyond the original Tk 667 crore allocation (Tk 831.88 crore had been spent by November 2024), and in February 2025 the factory was reported idle again, short of both gas and limestone. The founding plant thus plays almost no part in today's market, a reminder that Bangladesh has never had cement-grade limestone in quantity within its own territory.

The Import-Dependent Decades

For most of the twentieth century, Bangladesh simply bought cement from abroad. Production from Chhatak and from a Pakistan era grinding factory at Chittagong, which ground imported clinker and made none of its own, covered only a fraction of demand, and imports filled the rest. Consumption was tiny: per capita cement use was still only about 22 kilograms a year in 1999, according to industry histories, against roughly 200 kilograms or more in the mid-2020s. Construction was dominated by brick, and foreign exchange for imports was chronically short.

What changed the equation was not a discovery of raw materials, because there was none to discover. It was policy and demand. Liberalisation in the early 1990s opened manufacturing to private capital, remittance income and urban growth fed a housing boom, and entrepreneurs realised that a grinding plant did not need a quarry. It needed a jetty, a clinker supply contract and a distribution network: clinker bought by the shipload and ground near the market, blended with gypsum, slag, fly ash and limestone filler.

The Private-Sector Expansion from the 1990s

The 1990s brought the first wave of private grinding plants, clustered where imported clinker could be unloaded and demand was growing fastest: around Dhaka on the Shitalakshya, Dhaleshwari and Meghna rivers, at Chittagong, and at Mongla in the south-west. Crown Cement's plant at Munshiganj dates from 1994, as does the Mongla Cement Factory of the Sena Kalyan Sangstha (Elephant and Sena brands). Multinationals followed: the plant now run by Heidelberg Materials began as ScanCement International at Kanchpur near Dhaka in 1999, and Lafarge (later LafargeHolcim) built the country's only fully integrated plant at Chhatak, in production from 2006.

Growth then compounded for two decades. Government mega projects supplied the peaks of demand: the Padma Bridge, expressways, metro rail, tunnels, ports and power plants all justified ever larger mills. Private housing and rural construction supplied the base load, as remittance earners replaced tin and timber houses with brick and concrete. Vertical roller mills replaced older ball mills, allowing single plants of several million tonnes a year, and by the early 2020s Bangladesh ranked among the twenty largest cement markets in the world by volume.

The Major Producers Today

The market is top-heavy: industry trackers estimate that the five largest brands account for roughly three-fifths of sales volume and the ten largest for close to nine-tenths. The BCMA counts 76 registered companies, of which only about 42 were active in 2026, seven of them listed. Shah Cement, owned by the Abul Khair Group and in production since 2002, is the market leader: a 2025 equity research note citing BCMA figures put its share at about 13 percent of national sales. Bashundhara Cement (Bashundhara Group), Crown Cement PLC (listed, grinding at Munshiganj since 1994) and Fresh Cement (Meghna Group of Industries, strong in rural distribution) are among the other large producers. Premier Cement Mills PLC, also listed, is a major producer whose managing director, Mohammed Amirul Haque, serves as BCMA president. Seven Rings Cement, the brand of the Hong Kong based Shun Shing Group, was established in Bangladesh in 1999 and operates factories at Gazipur, Khulna (from 2014) and Chittagong (from 2021), with combined capacity the company states at 8.4 million tonnes a year.

The multinationals hold a significant minority: the BCMA estimates them at around 20 to 25 percent of installed capacity. LafargeHolcim Bangladesh PLC, a joint venture between the Swiss Holcim Group and Spain's Cementos Molins, has invested about 500 million US dollars in Bangladesh. Its Chhatak plant is the country's only fully integrated dry process cement plant, making its own clinker from limestone quarried in Meghalaya, India, and carried across the border on a 17 kilometre conveyor belt. It sells under the Supercrete and Holcim brands, held about 7 percent of the national market in 2025 according to equity research, and reported a 34 percent rise in annual profit for 2025. Heidelberg Materials Bangladesh PLC, renamed in June 2024 from HeidelbergCement Bangladesh in line with its German parent's global rebranding, sells the ScanCement and RubyCement brands, and Siam City Cement of Thailand is present through Insee. Behind the leaders sits a long tail of local groups, including Akij, Aman, Mir, Confidence, Metrocem, Anwar and Tiger.

Capacity Far Ahead of Demand

The defining argument in the industry today is about arithmetic. Producers built capacity for the market they expected: a decade of mega projects, rapid urbanisation and demand growth the BCMA puts at around 8 percent a year over the long run. The market they got after 2022 was smaller: sales slipped from close to 39 million tonnes in 2021 to slightly below 38 million tonnes in 2024, recovering to about 40 million tonnes in 2025, according to industry sources quoted in the financial press.

Against that demand, capacity figures vary by definition. The BCMA's plant-by-plant count, given in March 2026, was 86.02 million tonnes across 41 plants. Its president, in budget submissions the same season, spoke of installed capacity near 100 million tonnes and effective capacity above 82 million tonnes, while other BCMA-based reporting in 2026 put effective capacity at about 58 million tonnes against estimated demand of about 31 million tonnes. The definitions differ (nameplate against effective, registered against operating), but every version tells the same story: utilisation in 2025 was below half of effective capacity, and below the 60 to 65 percent threshold the BCMA calls necessary for sustainability.

Producers reject the word overcapacity. Their case, made publicly in March 2026 against criticism in a United States trade report, is that demand is highly seasonal, peaking in the dry months when monthly deliveries can reach about 4.5 million tonnes, that plants need reserve capacity for maintenance and supply shocks, and that at historical growth rates the existing capacity would be absorbed within eight to nine years. Per capita consumption supports the long-run argument: at roughly 210 to 223 kilograms in 2025 by industry estimates, Bangladesh uses far less cement per person than the global average of nearly 600 kilograms. The counter-argument is financial: idle capacity still carries interest costs, and smaller plants have already closed.

Built on Imported Clinker

Almost everything in a Bangladeshi cement bag starts overseas. The industry estimates that over 85 percent of its raw materials are imported. Bangladesh has no large deposits of cement-grade limestone, so with the single exception of LafargeHolcim's integrated Chhatak plant, producers do not manufacture clinker. They import it, along with granulated slag, fly ash, gypsum and some limestone, and grind the blend at home. National Board of Revenue figures for the 2025-26 financial year, as compiled by commodity brokers, put imports at about 19.2 million tonnes of clinker and 8.3 million tonnes of slag, with nearly 6 million tonnes of limestone and about 5 million tonnes of fly ash. Clinker, sourced mainly from Indonesia, Thailand and Vietnam, accounts for an estimated 60 to 65 percent of the cost of making cement.

This structure shapes the industry's economics. Bulk carriers discharge at the outer anchorage off Chittagong and at Kutubdia, and lighter vessels carry clinker upriver to plants on the Dhaleshwari, Shitalakshya and Meghna, which is why the map of cement plants is a map of navigable rivers. Costs also move with the dollar: the taka's sharp depreciation since 2022 raised the local price of every tonne of clinker, while weak demand limited how much could be passed to buyers.

Exports: A Small Trade to North-East India

Exports are a footnote. Cement is heavy and cheap, so it travels badly, and Bangladesh's one natural export market is the landlocked north-east of India, where Indian cement must travel far while Bangladeshi plants sit close to the border. The BCMA estimated shipments to India's Tripura state at roughly 20,000 tonnes a year in March 2026, and land customs figures reported in the press put exports through the Akhaura land port at about 22,000 tonnes in the 2022-23 financial year, with Crown, Seven Rings, Fresh, Insee, Premier and Shah among the brands sold there; Seven Rings has exported to India since 2008. Earnings are small and shrinking: reporting based on Export Promotion Bureau figures showed cement export revenue down by more than a quarter year on year in the first seven months of 2024-25, to about 7.71 million US dollars. The trade is a useful outlet for border-region plants, not a solution to surplus capacity, and political friction can interrupt it: in May 2025, Indian restrictions on trade through north-eastern land ports were reported to have disrupted exports through Akhaura.

The Construction Cycle and the Recent Slowdown

Cement demand is a mirror of construction, and construction has had a hard few years. The industry dates its decline from 2022: the Russia-Ukraine war raised fuel and freight costs, the dollar crisis squeezed letters of credit for raw material imports, and inflation and high interest rates cooled private building. The political changeover of August 2024 added a further shock, as public works paused and investors waited.

As of late 2026, the recovery remains fragile. The financial press reported in June 2026 that sales had fallen a further 3 to 4 percent in the first five months of the year, and in July 2026 the Daily Star reported implementation of the Annual Development Programme at its lowest rate in five years, with the BCMA president estimating that government infrastructure work had fallen by around 80 percent while urban housing demand had dropped sharply. Rural construction, funded substantially by remittances, has been the resilient segment. The Middle East crisis of 2026 then hit costs from the supply side: industry reporting in April 2026 estimated production costs up by 30 to 40 percent and output down by 20 to 25 percent after shipping through the Strait of Hormuz was disrupted, a shock producers said they could not pass on.

Energy Costs and the Gas Squeeze

Cement grinding is an electricity business as much as a materials one, and the integrated end of the industry is a gas business: mills need reliable power, kilns and captive plants need gas, and both have been scarce and expensive. The wider story is told in wikibangla's account of the power sector in Bangladesh: falling domestic gas production, rising liquefied natural gas imports and a supply gap industry feels first as low pipeline pressure. Cement makers share that squeeze with the ceramics industry in Bangladesh, whose kilns are even more sensitive to interruption.

The squeeze became an emergency in 2026. In April, the Dhaka Chamber of Commerce and Industry put the added cost of the energy shock at Tk 25 to Tk 30 per bag of cement. In late July 2026, a fire aboard a floating liquefied natural gas terminal at Moheshkhali took about 450 million cubic feet of gas a day out of the national grid for weeks. Reporting in August 2026 quoted the Premier Cement managing director estimating that stop-start running had raised production costs by at least 10 percent within a month, while one Meghna Group cement plant was reported running at under 5,000 tonnes a day against 30,000 tonnes of daily capacity in the worst of the shortage. LafargeHolcim, whose Chhatak kilns need gas continuously, moved to protect its supply by extending its gas sale agreement with Jalalabad Gas, agreed in principle in December 2024 to run from January 2026.

Consolidation and Outlook

An industry with twice the capacity it needs, high fixed costs and a handful of strong brands is set up to consolidate. The process has begun quietly: of 76 registered companies, only about 42 remained active in 2026, and the BCMA president has acknowledged that several small plants have closed. The listed and multinational producers have the balance sheets to wait out the cycle, and the strongest local groups can take share while prices are weak.

The long-run case remains intact. Bangladesh still uses roughly a third of the global average of cement per person, urbanisation continues, and the pipeline of bridges, ports, railways and economic zones that drove the last boom has been delayed rather than cancelled. If demand returns to anything like its historical growth rate of around 8 percent a year, today's surplus becomes the late 2020s' tight market, which is precisely the bet the capacity was built on. The risk is timing: plants financed at high interest rates must survive the present to reach that future, and survival depends on variables the industry does not set, including gas supply, the exchange rate, public development spending and clinker prices. For now, the makers behind the construction boom are waiting for the boom to resume, in an industry that has already built the factories for it.